MENENTUKAN POSISI TAP PADA TRANSFORMATOR DISTRIBUSI BERDASARKAN JATUH TEGANGAN PADA PENYULANG RASAMALA GARDU INDUK KEBON JERUK
Total View This Week0

Institusion

Institut Teknologi Perusahaan Listrik Negara

Author

Muslim, Ryo Susanto Pratama
Diantari, Retno Aita

Subject

Teknik Elektro 

Datestamp

2019-11-08 04:04:09 

Abstract :
ABSTRACT One of the quality of power supply is the quality of voltage received by consumers. The amount of voltage received by the electricity consumer is not the same, this is because of the impedance of the network. Therefore, Voltage Drop is always present on every part of the power system, from source to customer. Fall The voltage is directly proportional to the magnitude of the current and the phase angle, ie the current flowing through the power system. One of the fixtures to keep the service voltage within limits allowed, the distribution transformer is equipped with Off Load Tap Changer on the high voltage side. Based on SPLN NO 1: 1995 ie voltage variation or tolerance of service voltage is +5% and - 10%. So Rasamala penyulang said Good because the value is still under the provisions of 4,648% and tap position used is tap 2. 

File :
COVER.pdf
Lembar Pengesahan Kampus.pdf
BAB V.pdf
DAFTAR PUSTAKA.pdf
DAFTAR RIWAYAT HIDUP.pdf
single lone.pdf
PERNYATAAN KEASLIAN SKRIPSI.pdf
PERNYATAAN KEASLIAN SKRIPSI.pdf
abstrack inggris.pdf
DAFTAR ISI.pdf
UCAPAN TERIMA KASIH.pdf
BAB I DAN II fix.pdf
BAB III a.pdf
BAB IV RIO abc.pdf