IMPLEMENTASI PETURB & OBSERVE PADA MAXIMUM
POWER POINT TRACKING (MPPT) GUNA MENGOPTIMALKAN
DAYA KELUARAN BEBAN PADA SEL SURYA
Total View This Week0
Total View This Week0
Institusion
INSTITUT TEKNOLOGI DIRGANTARA ADISUTJIPTO
Author
RIZKI DALIMUNTHE, ERNANDO
Subject
T Technology (General)
Datestamp
2024-07-11 02:49:16
Abstract :
Photovoltaic is a device for converting solar energy into electrical energy. The electrical energy produced by solar cells depends on solar radiation and its temperature. Both parameters cause the solar cell output power characteristic curve to be non-linear. The output power of solar cells will change with changes in these two parameters. Therefore we need a device to optimize the photovoltaic output power that the resulting power is constant so that it can be used as a power supply. Optimizing the output power value of a solar cell requires a tracker. The tracking is called the maximum power point tracking (MPPT) which will produce a maximum output power value.. Each component in this system is modeled into Matlab-Simulink. This simulation is designed to optimize the work of solar cells by searching maximum power points using perturb and observe (P & O) algorithms, then duty cycles are output of the algorithms become Buck-Boost Converter inputs as switching so they can produce output power with better output power. Simulation results show that MPPT can increase the average output power on changes in the value of sun irradiation, temperature and load than systems that do not use MPPT. The factor of the average difference in power is 37,82%
Photovoltaic is a device for converting solar energy into electrical energy. The electrical energy produced by solar cells depends on solar radiation and its temperature. Both parameters cause the solar cell output power characteristic curve to be non-linear. The output power of solar cells will change with changes in these two parameters. Therefore we need a device to optimize the photovoltaic output power that the resulting power is constant so that it can be used as a power supply. Optimizing the output power value of a solar cell requires a tracker. The tracking is called the maximum power point tracking (MPPT) which will produce a maximum output power value.. Each component in this system is modeled into Matlab-Simulink. This simulation is designed to optimize the work of solar cells by searching maximum power points using perturb and observe (P & O) algorithms, then duty cycles are output of the algorithms become Buck-Boost Converter inputs as switching so they can produce output power with better output power. Simulation results show that MPPT can increase the average output power on changes in the value of sun irradiation, temperature and load than systems that do not use MPPT. The factor of the average difference in power is 37,82%
Download
book
BibTex
Latex, Jabref
cloud_download
Original Resource
url resource Institution
