PENGARUH SUHU DIE CASTING TERHADAP STRUKTUR
MIKRO PENGUJIAN TARIK DAN PENGUJIAN
KEKERASAN HASIL PENGECORAN PROPELLER BEKAS
Total View This Week0
Total View This Week0
Institusion
INSTITUT TEKNOLOGI DIRGANTARA ADISUTJIPTO
Author
STEVEN SILITONGA, MARK
Subject
T Technology (General)
Datestamp
2024-08-13 07:25:15
Abstract :
The objective of this research was to investigate the effect of die casting temperature to the tensile micro structure of the tensile testing and hardness testing from casting result of the second hand used propeller. The materials were the second hand used aluminium propeller. The materials were melted over the casting furnace and poured into a mold with the temperature variations were 85° C, 110° C and 143° C with a temperature of pouring of 689° C. The result of casting then was made into the speciment of the micro structure testing, composition testing, and tensile testing with result that the 85° C mold temperature variation had the highest tensile strength of 18,82 Mpa and the 110°C mold temperature variation had the lowest tensile strength of 10.92 Mpa. Vickers hardness testing with 110° C mold temperature variation had the lowest hardness of 69,883 VHN. This was due to the slow pouring and resulting in a decrease in temperature while at 143° C mold temperature variation had the highest hardness of 74,463 VHN. This was caused by the high mold temperature and high temperature pouring then the freezing rate was slower. These data indicated that the changes temperature in the mold had significant effect on the tensile testing and hardness testing of the recycled products.
The objective of this research was to investigate the effect of die casting temperature to the tensile micro structure of the tensile testing and hardness testing from casting result of the second hand used propeller. The materials were the second hand used aluminium propeller. The materials were melted over the casting furnace and poured into a mold with the temperature variations were 85° C, 110° C and 143° C with a temperature of pouring of 689° C. The result of casting then was made into the speciment of the micro structure testing, composition testing, and tensile testing with result that the 85° C mold temperature variation had the highest tensile strength of 18,82 Mpa and the 110°C mold temperature variation had the lowest tensile strength of 10.92 Mpa. Vickers hardness testing with 110° C mold temperature variation had the lowest hardness of 69,883 VHN. This was due to the slow pouring and resulting in a decrease in temperature while at 143° C mold temperature variation had the highest hardness of 74,463 VHN. This was caused by the high mold temperature and high temperature pouring then the freezing rate was slower. These data indicated that the changes temperature in the mold had significant effect on the tensile testing and hardness testing of the recycled products.
Download
book
BibTex
Latex, Jabref
cloud_download
Original Resource
url resource Institution
